Matrix-orbital GLK24064-25 Legacy Bedienungsanleitung PDF herunterladen (Seite 6)

1. Insert the Matrix Orbital Cd-ROM into the Cd drive.

2. Locate the ﬁle "mogd.zip". It should be in the “Download” directory.

3. Unzip mogd.zip to a temporary directory, using a program such as Winzip, Pkzip, etc.

4. Double click on "setup.exe".

5. Follow the instructions on the screen to complete the installation.

After installation is complete there will be a Matrix Orbital entry under “Programs” in the “Start Menu”.

Click on this entry to run mogd.exe.

The ﬁrst time mogd.exe is run, some information will be required;

• The port number to be used. (Usually COM1 or COM2)

• The baud rate for the connection. (Use 19,200 for initial startup of the display)

• The type of display unit. (Set to 240 x 64 for the display)

Once this information is entered the program can be used to control all functions of the display.

1.5 Trying Out the GLK24064-25

Matrix Orbital suggests testing the display out before setting it up for any application. This is easily

done with a PC. The following will be required;

• A 5V power supply. (8 to 30 VDC for Efﬁcient Switching Supply (VPT) models)

• A power connector. The type used for 3.5” ﬂoppy drives works ﬁne

• A PC with a spare RS-232 port (COM1 or COM2)

• The mogd.exe program, installed as in the previous section

• A 9 or 25 conductor RS-232 serial cable. If using a 25 conductor cable, a 25 to 9 pin adapter will also

be required

The back view of the GLK24064-25 is shown below for reference.

Figure 1: Rear View of GLK24064-25

1.5.1 Here’s what to do:

1. Refer to the Figure above for the following steps.

Matrix Orbital GLK24064-25 2

1 2 3 4 5 6 7 8 9 10 11 ... 46 47

Keine Kommentare

Matrix-orbital GLK24064-25 Legacy Bedienungsanleitung Seite 6