
46 Command Summary
6.14 Filesystem
254 33 89 33
FE 21 59 21
■ ! Y !
Completely erase all fonts and bitmaps from a graphic display. Extended length of the command is intended to
prevent accidental execution. To ensure filesystem integrity, cycle power to the display after erasure.
Removes a single font or bitmap file given the type and unique identification number. Cycle power after deletion.
0 for font or 1 for bitmap.
Unique identification number of font or bitmap to be deleted, value between 0 and 1023.
*Note: ID was changed from a Byte length at firmware revision 8.1
14.3 Get
Filesystem Space
Returns the amount of space remaining in the display for font or bitmap uploads.
Number of bytes remaining in memory.
14.4 Get Filesystem
Directory
Returns a directory to the contents of the filesystem. The total number and type of each entry will be provided.
8 identification bytes for each entry.
Table 36: Filesystem Identification Bytes
Table 37: Extended Byte Descriptions
First four bits designate file type, 0 for font or 1 for bitmap, remaining 12 bits indicate ID number.
Memory start page, a value of 0 indicates entry is not in use.
*Note: ID and Size were changed from Byte and Short lengths respectively at firmware revision 8.1
Size Data
Size Data
Size Data
This command will upload a filesystem image to the display. The size used is almost always the entire memory.
Filesystem data can be uploaded LSB to MSB using the
File Transfer Protocol.
Size of the filesystem to upload.
Filesystem data to upload.
Kommentare zu diesen Handbüchern